Equipment needed: a battery-operated screwdriver, screwdriver bits (Phillips and standard), hex head driver, tape measure and scissors. Although no special equipment is usually required when installing window treatments, proposed to use a battery operated screwdriver or drill to make the job easier. First, un-pack treatment and careful you are NOT using a razor or knife to open the box. Very easy to cut the rope or blind by doing this. Be careful when out of the box treatment sent to; some better treatment than others. Remove all packaging used in shipping, more care to do so. Put the window treatment is installed, would be very helpful if several different treatments for the windows because to get them mixed up. Then put all the mounting hardware on the windows installed with care to them. Make sure you have the right tools for the job, such as screws and hardware will vary.

Horizontals: Install brackets making sure to use the correct bracket for the right side (some have the brackets left and right, and some are not). After the brackets are installed, open the section in brackets with a lift gate brackets. Place the blind in the brackets and close the door, and make sure both sides are safely closed. If a blind person has a mosquito net mosquito net clip site on the head before putting the train blind in parentheses. Attach a mosquito net for blind headrail. Lower blind using the lift cord, then rotate the blind in the same direction to ensure operating properly.

Shades: Install shade brackets. Snap shade in place. (Because shades and brackets vary, see the installation instructions provided with the color). Reduce shade by pulling the shade lift cord. This is usually done by pulling the shade lift cord to the left to release, and the right to lock it.

Vertical: For the mountains in the first vertical mounting nets. (Some may require trimming first Valances). Mount brackets under a mosquito net in the proper position to allow the rib to move without disturbing the bed nets. Snap track into place. Hang the blade and make sure they were all filmed in a safe place. Attach the tension pulley rope to the wall and adjust the voltage so secure but not tight.

To the mountains outside the vertical: Proposal to place you together for the brackets, and make a mark. With the top of the bracket bolt holes, tighten the screws on the holes where you made the sign. Other places under the screw hole. Center track over window and snap it into place, make sure the right safe. Attach the rib cage, making sure each one is mounted. Brackets break head to the rail bed nets if they develop them in parentheses. Center on the track bed nets and mosquito nets where the vertical holder. (Some Valances may take a little knock on the handle to secure the palm of the hand). Mount the tension pulley to the wall and adjust the voltage so secure but not tight. Drawing the curtains and so forth, and rotate them to ensure they function properly.